Old 12-02-10, 09:13 PM
  #5  
Al1943
Senior Member
 
Join Date: Feb 2005
Location: Oklahoma
Posts: 9,438

Bikes: Trek 5500, Colnago C-50

Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 4 Post(s)
Likes: 0
Liked 7 Times in 6 Posts
Originally Posted by BCRider
Start by checking that the axle on each side is flush or below the outer face of the dropout. If it's not then you aren't tightening the proper stuff.
This is what I'm wondering. If dropouts are horizontal the ends of the axle needs to be within the dropout plates. If not the skewer or axle nuts cannot tighten against the dropout plate.
Al1943 is offline