Originally Posted by
joshuastar
+1.
i posted it for a reason.
Then why didn't you just answer my original post by saying "yes, this method will work for you", since I made reference to the oven cleaner method which should also serve as a hint that I've read the DIY thread. The Tektro lever is NOT anodized, and I was right to assert that no one talked about removing powdercoating with the Easy-Off method before, let alone in the DIY thread.
I simply went with 100 grit sandpaper followed by a green 3M scotch pad. Leaves a nice, brushed looking surface. Dremel tool with wire wheel is another quick method and will let you get into the cramped bits.
I was looking to match the finish on my new bars - see pic
Nice job, atomicbob. In fact, nice job on the stem/bars/tape, too. Is that shellacked cloth tape?
(Wish I had a dremel.)