Bicycle Mechanics - Sturmey-Archer 3-Speed Hub
Bikeforums.net is a forum about nothing but bikes. Our community can help you find information about hard-to-find and localized information like bicycle tours, specialties like where in your area to have your recumbent bike serviced, or what are the best bicycle tires and seats for the activities you use your bike for.
01-02-06, 09:08 AM
How do these things work? I have a couple of exploded drwings that show a planetary gear system, but it has a single gear in the center, three planetary gears, and a "female" gear that presumably drives the hub. Looks to me like that arrangement would only work in single-speed mode, so there must be something I am missing......
01-02-06, 10:12 AM
Planetary gears allow two different gear ratios depending on which element is held and which are free to move. If the planet carrier is held, you get one gear, if the sun gear is held you get a different ratio and if the entire set is locked, you get a 1:1 or direct drive so there are three different ratios available with one gear set.
BTW, the "female gear" is more correctly known as the "ring gear"
01-02-06, 11:15 AM
This is from Sheldon Brown, at this page: http://www.sheldonbrown.com/sturmey-archer.html
(Thanks for asking a great question)
"...Internal-geared hubs work on the principle of "planetary gearing."
The basic 3-speed hubs have a single "sun" gear solidly attached to the middle of the axle. A set of 3 or 4 identical "planet" gears mesh with and revolve around the "sun" gear. The "planet" gears are surrounded by (and mesh with) an inside-out "gear ring".
As the planet gears, attached to a part called a "planet cage" revolve, the gear ring revoles 4 times for every 3 times the planet cage goes around. (Some models have different ratios.)
Low Gear has the sprocket driving the gear ring, while the planet cage drives the hub. Thus, the wheel turns 3 times for every 4 revolutions of the sprocket, lowering the gear by 25%.
Middle Gear has the sprocket still driving the gear ring, but has the gear ring drive the hub. Thus, the drive is direct. Although the internal gears are always rotating when the sprocket is in motion, they don't have any effect on the drive in middle gear.
High Gear shifts the sprocket's drive to the planet cage, while the gear ring continues to drive the hub shell. Thus, the hub turns around 4 times for every 3 sprocket revolutions, giving a 33% gear increase..."
Powered by vBulletin® Version 4.1.12 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.