BMX - AtomLab Pedal DU bearing experiences?

Bikeforums.net is a forum about nothing but bikes. Our community can help you find information about hard-to-find and localized information like bicycle tours, specialties like where in your area to have your recumbent bike serviced, or what are the best bicycle tires and seats for the activities you use your bike for.



PDA
mx_599
02-06-06, 09:11 PM
any of you use this bushing system? or has a friend who does??

i came across Atomlab's DU pedals. read about them below. i figure they must be pretty tough with tight tolerances if they are also used on the crank shaft of an automobile engine!!

so long as i don't hear anything majorly negative about them, they're going to be what i get next time. the O-ringed tension keeps them from spinning when your foot comes off the pedal too

http://www.atomlab.com/peddu.html

comments?

CMcMahon
02-06-06, 10:03 PM
bushings =/= bearings
mx_599
02-06-06, 11:00 PM
bushings =/= bearings
thanks...do you know anything about them, good or bad?

CMcMahon
02-06-06, 11:02 PM
Aside from the fact that they're overly expensive and almost no ones rides them for that reason? No. Just get Odysey Jim Cs.
mx_599
02-06-06, 11:07 PM
Aside from the fact that they're overly expensive and almost no ones rides them for that reason? No. Just get Odysey Jim Cs.
okay