Singlespeed & Fixed Gear - Decent bullhorn + tt levers

I want to put bullhorn bars and a tt brake lever. I have mainly been looking at chucks, performance bike, and nashbar. I really wanted a chrome bar to match my chrome pista frame, but i have not be able to find any (besides fliping and chopping some drop bars).

The bars ive been looking at are:

Profile Design Airwing TT Handlebar
http://www.performancebike.com/shop/profile.cfm?SKU=4980&subcategory_ID=5255
It says "Grooved cable guides for aerodynamics and comfort", but is that internal or external?

Profile Design Stoker TT Bar 26.0
http://www.universalcycles.com/shopping/product_details.php?id=5293&category=1275
internal routing.

Nashbar Time Trial Handlebar
http://www.nashbar.com/profile.cfm?category=92&subcategory=1050&sku=8448&brand=
It says "single cable groove", so external right?

Nitto bullhorn
http://cgi.ebay.com/Nitto-RB-018-Bullhorn-Handlebar-42cm_W0QQitemZ7220270005QQcategoryZ27951QQtcZphotoQQcmdZViewItem
Internal or external?


For the levers, i have looked at a lot and they all seem pretty similar. I dont need anything real special, so im looking for the best value here.

The whole point of this thread was to get some reccomendations from you guys. I dont know what levers and bars are compatible so hopefully i can get that figured out. Let me know which bars you would pick and what levers to match them with. Thanks!

I'm a huge fan of my Syntace Stratos bars. They fit your arms and wrists perfectly. When I first tried them I didn't even feel like I was holding anything.

Profile Design Stoker TT Bar 26.0
http://www.universalcycles.com/shopping/product_details.php?id=5293&category=1275
internal routing.
I just put a set of those on my Milwaukee this past weekend. I like them. Previously I had the Nitto ones with the drop, and found them uncomfortable. The internal cable routing is wierd... the holes are on the SIDES of the bars. I have a single Cane Creek TT200 brake lever, and the cable exits outside the bars, and on the underside. If I wanted to use the internal routing, I'd have to route it from the middle bottom of the bar over to the side, into the bar, then out the side again.

I said fsck that, and just ran the cable along the bottom of the bar under the tape.

http://home.comcast.net/~michaelnel/mural_bars_800.jpg

Hmm i like the stokers too. I think i would just get a lever that i could just run the cable straight into without rout it back out.

have used the Stratos bars before, but i recently switched out to some syntace, simply for the fact that they came back a little on the flat before going forward. the stratos are still good bars though.

if you want silver this is what i have, but mine are black
http://cgi.ebay.com/Syntace-Time-Trial-Bar-42_W0QQitemZ7221097375QQcategoryZ27951QQrdZ1QQcmdZViewItem
http://i2.ebayimg.com/02/i/06/56/5f/3d_1_b.JPG

i rock the stokers and i love them.

I like the Stoker 26 from Profile. I polished mine since I didn't want black.

http://i49.photobucket.com/albums/f287/gransport/fix7.jpg

Good luck
Shayne

i got the nashbar tt levers. they have external cable routing. i'll send you one if you want. it doesn't have the little rubber end cap though.