O.K., so I don't have a kingdom, but I do have a cyclocross bike and a set of arms that are too long for a 100mm stem, and too short for a 110mm stem. There are about ten thousand hundred stems out there, and I know that I have a lot of looking around to do. To cut down on the work, I was hoping you could all help out with some reccomendations. The stem will connect a Cannondale Optimo Cyclocross 2005 to Cinelli Altera handlebars. I would like to spend less than about seventy dollars for a stem that is strong, light, and is sized to fit my steerer tube and bars. Oh yeah, don't forget, must be available in 105mm.

Thanks,
Jpearl.

if you can't find the magic stem you can adjust reach quite a lot with different bars and between stem and bar combo you should be able to get the reach you want to within a mm.

if you can't find the magic stem you can adjust reach quite a lot with different bars and between stem and bar combo you should be able to get the reach you want to within a mm.That's what I was about to say...

I run the Ritchey Pro bars cause the extension's 85mm. Adds that extra 5mm that I need.

HTH,

M

syntace f99 very light and about $70 i love mine have em on all my bikes.

jeremy

I honestly can't see 5mm being that critical, you can move your seat forward or back if it is that critial, the body is pretty adaptable

Nix on moving the saddle forward 5mm. I had it custom set by my bike shop using all of the bells and whistles used to customize the saddle hieght, fore-and-aft position, and angle. And besides, I usually move backwards on the saddle when hammering big gears on the flats. If anything, I would prefer to move my saddle backwards, but better judgement, and the knowledge of the guy who set my rig up, is going to keep the saddle where it is. I actually just flipped the stem over and lowered the stack hieght a bit to get a more agreeable position, pulling the bars closer in for better bike handling on tricky trail sections, but still low enough to let me cruise on paved surfaces.

Nix on moving the saddle forward 5mm.

Yup, you got it right - you don't want to change your saddle geometry! That should be a fixed value.

However, I do agree that 10mm shouldn't make that much of a difference @ the stem level. I would use the 110mm stem, and allow my body to adapt to the slightly (2/5th of an inch) longer reach. Good luck!