Singlespeed & Fixed Gear - IRO wheel ??
Bikeforums.net is a forum about nothing but bikes. Our community can help you find information about hard-to-find and localized information like bicycle tours, specialties like where in your area to have your recumbent bike serviced, or what are the best bicycle tires and seats for the activities you use your bike for.
05-13-06, 10:42 AM
I purchased a set of IRO's deep V's wheelset and was wondering if I should have them tensioned, trued and de-stressed before slapping these on and riding. Do you think IRO does a good enough job making sure everything is up to par. Whatcha think?
05-13-06, 11:24 AM
I'm 265 pounds, I've been beating the hell out of my IRO hubs laced to velocity aeroheads, I've yet to retrue them. you'll be fine. unless you weigh like 350...
05-13-06, 11:53 AM
IRO seems to build a pretty good wheel. Mine was true and properly tensioned right out of the box, and the first time I needed to true it was after ~6 months of daily riding. That being said, I'm not that heavy (140lbs, i think), and I try to be nice to my wheels.
Anyway, before you go ride any new wheelset, you should always check the spoke tension and trueness. You don't need to take it to the shop for this, just eyeball the rim once you have it on the bike, and make sure it spins true. For spoke tension, grap two parallel spokes and squeeze them together, and keep doing this until you have tested them all. Anything obviously loose should be tightened. If they are out of true, they should be adjusted before riding.
After riding the first 100 miles or so (less if you are using it in the city), check everything again, since trueness and spoke tension often change during break-in. Adjust if necessary. If you aren't comfortable doing it yourself, this is the time to take it to the shop, but I would advise everyone to do some internet/bike forums searching and attempt to learn to true your own wheels. It's not that difficult, and it's a great skill to have.
05-13-06, 12:26 PM
Thanks space robot, thats the 2nd opinion I was looking for, I will take them in and have them done the right way.
05-13-06, 03:04 PM
I have the IRO hubs laced to Aeroheads too, and the only time i've had to retrue them was when a friend blatently ran into me while attempting to not hit a car. other than that you can beat the piss out of the and not have to worry.
never retrued mine, had em for about a year. whether thats negligence or good wheelbuilding im not sure, but take it for what its worth
my deep v wheelset came tight and true out of box. i recently had the front retrued after i broke a spoke hitting a pothole - however it was just to tighten things up because the wheel itself was still true.
Powered by vBulletin® Version 4.1.12 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.