Mountain Biking - Chain wheel?
Bikeforums.net is a forum about nothing but bikes. Our community can help you find information about hard-to-find and localized information like bicycle tours, specialties like where in your area to have your recumbent bike serviced, or what are the best bicycle tires and seats for the activities you use your bike for.
07-03-06, 06:28 PM
I have a Norco Havoc which is a single speed. I recently took of the chain wheel to replace my crank arm. When I put everything back together on the bike, it seemed like the chain wheel was "lop sided". When I turn the cranks, the chain would go tight and than get loose and than go tight again, just in a few revolutions, and keep going like that. So I took it off again and tryed to put the chain wheel in stright. This time it wasn't as bad but still not good. Anyone got any soulutions to this problem? Thanks?
07-03-06, 09:41 PM
Re-seat the chain ring?
07-03-06, 09:42 PM
Chain wheel? What part are you talking about?
07-04-06, 09:29 AM
There is a screw on my crank arm about 2 inches from where the BB axle go throught. This is where I connect my chain wheel (I think that is what its called). I can never seem to get the screw in the center, and when I do the chain wheel just slides over (only about a few millimeters.
Powered by vBulletin® Version 4.1.12 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.