Mountain Biking - Wheel Damage
Bikeforums.net is a forum about nothing but bikes. Our community can help you find information about hard-to-find and localized information like bicycle tours, specialties like where in your area to have your recumbent bike serviced, or what are the best bicycle tires and seats for the activities you use your bike for.
08-15-06, 05:57 AM
Ran over a nail (BIG one) this morning that managed to penetrate wheel, tube, AND part of the rim as shown here:
The nail is one of those big ten penny variety. The red arrow depicts how far the nail went into the rim. My question is do I need to be concerned about the structural strength of the wheel now?
08-15-06, 09:03 AM
08-15-06, 09:39 AM
I doubt that the wheel's strength would have been seriously compromised by a single punched hole. However, I would not take the risk if I were you, I'd get the rim replaced asap.
08-15-06, 09:48 AM
The rims strength comes from the circular shape, and if the sheet of metal that creates that shape is damaged, the wheel strength goes down.
My question is do I need to be concerned about the structural strength of the wheel now?
If your spoke nipples are in upside down like in the drawing...yes.:D
08-15-06, 04:44 PM
As long as there arn't any deep ruts or jagged edges, it's probably fine. Smooth it out and put tape of some kind (electrical would probably be best) over the area so that it doesn't puncture the tube.
Powered by vBulletin® Version 4.1.12 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.