HelluvaStella
12-21-06, 02:39 PM
A friend has a no-label conversion (aluminum, vert dropouts) that has a diamond cross section down tube. The serial number starts with "IF"
Any ideas as to the make?
Any ideas as to the make?
Singlespeed & Fixed Gear - Help with a frame identification?
Bikeforums.net is a forum about nothing but bikes. Our community can help you find information about hard-to-find and localized information like bicycle tours, specialties like where in your area to have your recumbent bike serviced, or what are the best bicycle tires and seats for the activities you use your bike for.View Full Version : Help with a frame identification?
iamjberube
12-21-06, 09:29 PM
independant fabrications?
Aeroplane
12-22-06, 04:54 AM
independant fabrications?
If that's the case, I would cry myself to sleep.
If that's the case, I would cry myself to sleep.
HelluvaStella
12-22-06, 05:52 AM
That was my first guess, but I know nothing about them. This frame doesn't look like anything special, kinda Trek-ish with ugly welds.
scrublover
12-22-06, 06:14 AM
That was my first guess, but I know nothing about them. This frame doesn't look like anything special, kinda Trek-ish with ugly welds.
AFAIK, I.F. doesn't/hasn't done anything other than steel and the rare ti frame. Never heard of them doing any alu stuff, even as one off jobs. I'd highly doubt it's an I.F.
AFAIK, I.F. doesn't/hasn't done anything other than steel and the rare ti frame. Never heard of them doing any alu stuff, even as one off jobs. I'd highly doubt it's an I.F.
Fixxxie
12-22-06, 08:25 AM
Marin has tube shaped like that on some frames