Framebuilders - Building a SWB Recumbent
Bikeforums.net is a forum about nothing but bikes. Our community can help you find information about hard-to-find and localized information like bicycle tours, specialties like where in your area to have your recumbent bike serviced, or what are the best bicycle tires and seats for the activities you use your bike for.
Hi, I'm about to embark on building a swb recumbent and need a bit of advice. Will 2 inch diameter, 0.049 wall thickness 4130 cromo suffice? Will I need to post heat treat the frame? Can I weld other "normal" steel components onto the cromo frame such as rear forks, head set ect or am I restricted to cromo components?
Any help would be greatly appreciated?
You don't need to post heat treat the chromo assuming it was not hardened in the first place. Normal aircraft tubing is not hardened.
I don't know what kind of recumbent you are planing, but one thing to consider is if there is anything penetrating the frame. Like on mine, the head tube goes right through the main beam, which requires a pretty huge hole.
You can weld other steel components onto chromo. As long as they do not require the strength that chromo has. An illustration would be the springer front end on a chopper. When these get raked out and low enough, the angle can be about 30 degrees from the horizontal, and a most effective means of providing suspension is to have just two 4130 tubes. If you consider that situation, a normal cold rolled tube of the same dimensions, would be just as flexible and provide the same ride, except it would not have the strength. So anything you are attatching to your frame that does not require great strength in the most efficient dimensions, can be made out of mild or CR as long as the loads are not going to be too great. So an obvious example would be a home made cable stop out of mild. You don't have to worry about it being too weak, and it will weld to the Chromo fine also. Though chromo is known to weld with a very nice bead, when the proper filler wire is used.
Thanks very much for that. With this SWB recumbent, I'm going to run a 2 inch tube and scoop out a hole to allow the head tube. From your advice, I'm now not sure about attaching back forks and crank given that they will be significantly weight/force loaded? The plans I'm following are from http://funnyfarmart.com/plans.htm. Plan Version VI.
01-03-07, 08:03 PM
That design is very much like some of the Volae and Bacchetta models that are made with 2" x 0.035" 4130 tubing. 0.049" should be more than adequate.
Powered by vBulletin® Version 4.1.12 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.