Bicycle Mechanics - brake?
Bikeforums.net is a forum about nothing but bikes. Our community can help you find information about hard-to-find and localized information like bicycle tours, specialties like where in your area to have your recumbent bike serviced, or what are the best bicycle tires and seats for the activities you use your bike for.
02-01-07, 05:28 PM
Trying to install a front brake on an old frame.
The problem: the screw for the brake fits into the hole, but the bolt-type mechanism (that holds the brake on the bike- sorry for lack of technical terms) doesn't fit in the hole.
what's the best option? try to find a smaller bolt? or drill a slightly larger hole to make it fit?
02-01-07, 05:39 PM
You need to drill out the back of the fork to accept the recessed nut. Oh what the hell i'm just going to quote shledon.
Front: Here are 3 options:
Drill out the back of the fork crown (8 mm or 5/16 drill bit). This is actually quite easy to do with a handheld electric drill, since you're only enlarging an existing hole.
That's it if you can get two front calipers. Sometimes, you may have to deal with a pair of brakes, with one long and one short bolt. If you used the long one in back, you can use the short one in front two different ways:
Drill out the back of the fork crown and use an extra-long recessed nut. These nuts are commonly available for use in carbon fiber forks.
Use the short recessed nut, but don't put it through the back of the fork. Instead, push it up into the inside of the steerer from the bottom. You can reach a 5 mm Allen wrench in through the hole in the back of the fork, and poke the short caliper bolt in from the front.
You may need to shorten the recessed nut slightly to get it to fit inside your steerer.
Powered by vBulletin® Version 4.1.12 Copyright © 2014 vBulletin Solutions, Inc. All rights reserved.