Bikeforums.net is a forum about nothing but bikes. Our community can help you find information about hard-to-find and localized information like bicycle tours, specialties like where in your area to have your recumbent bike serviced, or what are the best bicycle tires and seats for the activities you use your bike for.pippo
02-10-07, 08:36 PM
OK so I'm replacing the left shifter cable on my Dura Ace 7800 system.
My problem is that the barrel piece on the end of the shifter wire won't seat into the hole in the brifter.
I turned it around (just to make sure it fits) and it pops in no problem, but when I thread the wire through all the way the barrel won't go into the hole. Just not the right angle. Do I have to dismantle the brifter to get this to seat?
So I am asking the experts here what the trick to getting this barrel seated it.
Thanks in advance.
My problem is that the barrel piece on the end of the shifter wire won't seat into the hole in the brifter.
I turned it around (just to make sure it fits) and it pops in no problem, but when I thread the wire through all the way the barrel won't go into the hole. Just not the right angle. Do I have to dismantle the brifter to get this to seat?
So I am asking the experts here what the trick to getting this barrel seated it.
Thanks in advance.