Singlespeed & Fixed Gear - Rear hub installation ? *pics*

Bikeforums.net is a forum about nothing but bikes. Our community can help you find information about hard-to-find and localized information like bicycle tours, specialties like where in your area to have your recumbent bike serviced, or what are the best bicycle tires and seats for the activities you use your bike for.



PDA

View Full Version : Rear hub installation ? *pics*

RboarderI
09-11-07, 09:06 PM
I rebuilt my rear hub for a single speed that I am putting together and might have lost a part. I re-lubed everything and put the bearings back in but now I am unsure if I have all of the pieces to tighten up the axle. Right now I have the bearing cone in there as you can see in the picture. My question is, do I put the white cap and then the lock ring or am a missing a part in between. When I tried to tighten it back together it was clamping down the bearings and was not able to spin correctly. Anyone have an answer?


http://img.photobucket.com/albums/v158/rboarderi/Bike/IMG_6326.jpg


http://img.photobucket.com/albums/v158/rboarderi/Bike/IMG_6327.jpg

mrsalty
09-12-07, 03:07 PM
I rebuilt my rear hub for a single speed that I am putting together and might have lost a part. I re-lubed everything and put the bearings back in but now I am unsure if I have all of the pieces to tighten up the axle. Right now I have the bearing cone in there as you can see in the picture. My question is, do I put the white cap and then the lock ring or am a missing a part in between. When I tried to tighten it back together it was clamping down the bearings and was not able to spin correctly. Anyone have an answer?


http://img.photobucket.com/albums/v158/rboarderi/Bike/IMG_6326.jpg


http://img.photobucket.com/albums/v158/rboarderi/Bike/IMG_6327.jpg



does the cone taper enough to go on after the dust cover?
dutret
09-12-07, 03:13 PM
yes