General Cycling Discussion - How short a stem can I go on a 2006 Trek 1500?

Bikeforums.net is a forum about nothing but bikes. Our community can help you find information about hard-to-find and localized information like bicycle tours, specialties like where in your area to have your recumbent bike serviced, or what are the best bicycle tires and seats for the activities you use your bike for.
Canadian
04-14-08, 03:45 PM
I'm a female; I think my reach is too long on my Trek 1500. I'm struggling to figure out how to shorten the stem. I know it comes with Bontrager Select OS/7d and I've checked the website http://bontrager.com/model/04057/en but now I'm confused. How do I know what size stem I'm using? I'm on a 54 cm.
http://www.sheldonbrown.com/gloss_ha-i.html#headset
To change the stem see above
To get the right length you may need to go into the LBS and get a bike fit done.
I'm a female; I think my reach is too long on my Trek 1500. I'm struggling to figure out how to shorten the stem. I know it comes with Bontrager Select OS/7d and I've checked the website http://bontrager.com/model/04057/en but now I'm confused. How do I know what size stem I'm using? I'm on a 54 cm.
There are four measurements for a stem: angle, length, steertube clamp size and handlebar clamp size.
Most steertubes these days are 1 1/8 inches. A few are 1 inch
Most handlebars these days are 31.8mm which is also known as OS (oversize). That's because the standard used to be 26.0, but from what I see, the OS is much more common now.
I "think" you're asking about length. Often it's marked on the stem and common lengths are 90, 100, 110, 120 mm. 80 and 130 are also fairly common. Those lengths are sometimes stated in cm instead of mm - therefore, 9, 10, 11, 12 cm.
If you're not sure about the length, you can easily measure it. The stem extends from the steer tube to the handlebars. Measure from the center of the steer tube (it has a cap which has a small bolt in the center - use that) to the center of the handlebar clamp. If you're using a US ruler, convert to cm by multiplying by 2.54 or to mm by multiplying by 25.4.
Canadian
04-15-08, 06:26 PM
Thanks for the help! I truly appreciate it.
And, incidentally, I'm Canadian, so no need to do the math! :D
Thanks for the help! I truly appreciate it.
And, incidentally, I'm Canadian, so no need to do the math! :D
DOH, I guess the user name would be a hint?
Good luck!
SweetLou
04-16-08, 11:31 PM
Thanks for the help! I truly appreciate it.
And, incidentally, I'm Canadian, so no need to do the math! :DBut you also mentioned that you are female. :rolleyes:
Sorry, I couldn't let that go by. ;)
Powered by vBulletin® Version 4.1.12 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.