Bicycle Mechanics - RX 100 Front shifter
Bikeforums.net is a forum about nothing but bikes. Our community can help you find information about hard-to-find and localized information like bicycle tours, specialties like where in your area to have your recumbent bike serviced, or what are the best bicycle tires and seats for the activities you use your bike for.
05-04-08, 01:40 PM
My daughter was just given a road bike with rx100 8speed components on it. Every thing works great except the front shifter. It moves smoothly but will not click and stay on the large chain ring. It looks like it has hardly been used but one never knows. Any ideas on the problem? I have a feeling I already know the answer but wanted to check on fixes before I looked for a replacement.
05-04-08, 01:51 PM
check the cable it mat be to tight . readjust if needed ,also check the high adjustment strew on the front dérailleur , it may need to be back off some. about 1/8 to 1/2 a turn.
05-04-08, 10:14 PM
Is this one of the integrated shift/brake levers? (brifter, STI, etc)
If so...the grease Shimano used/uses tends to get sticky after a while...you might be able to spray something like WD40 into it to loosen the gumminess...
05-05-08, 09:30 AM
If you're lucky and it really is a shifter with very few miles on it, the factory lube inside it may just be stiff.
Do you have access to compressed air? If so, spray WD40 inside the shifter "blade" (the parts assembly attached to the brake lever part of the unit) then blast compressed air through it. Repeat this 3 or 4 times. If the shifter's problems aren't a result of mileage and wear you should see an improvement.
05-05-08, 07:46 PM
Thank you!!! The WD40 and compressed air worked like a charm.
Powered by vBulletin® Version 4.1.12 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.