Utility Cycling - Axle too short for trailer coupler?

Bikeforums.net is a forum about nothing but bikes. Our community can help you find information about hard-to-find and localized information like bicycle tours, specialties like where in your area to have your recumbent bike serviced, or what are the best bicycle tires and seats for the activities you use your bike for.



PDA
rumi
07-18-08, 01:08 AM
I have a Trek 7.3 on which I'm trying to install a Schwinn/Instep coupler for our child trailer. The coupler attaches to the back axle (quick release). However, it seems that the axle is just barley enough as is; when I add the coupler, the axle will not reach through to meet the nut on the other side. Has anyone else experienced this, and is there a solution? The couple attaches fine to my old junker hybrid, but I'd much prefer to use the new ride for the trailer.
Thanks.

Kimmitt
07-18-08, 03:57 AM
Yep, I had the same exact problem with that coupler on my Electra Townie. I did not find a good solution and had to MacGuyver a hitch.
Maxwell
07-18-08, 04:42 AM
Some quick release skewers are longer than others, i'd try taking it to a shop, generic skewers are often a little longer to accommodate the beefiest possible dropouts.