Bikeforums.net is a forum about nothing but bikes. Our community can help you find information about hard-to-find and localized information like bicycle tours, specialties like where in your area to have your recumbent bike serviced, or what are the best bicycle tires and seats for the activities you use your bike for.gschnapp
03-03-04, 08:21 AM
Hello,
I posted alittle while ago about my ss converson. I was giving it another go and I noticed that my rear wheel was still off center, I guess I didn't get the dish right. The trouble is that the spokes are bottoming out on the right side, I was going to rebuild the wheel (I have built about 6 - 10 years ago, little rusty!)so I checked a number of sites w/ spoke calc., I am getting some diff. lengths and was wondering the best way to proceed? Sometimes the diff. is 1 mm/1.5mm.
rim-549
hub dia.-45
center to flange-27
x3 - 36h
Thanks once again,
Greg
I posted alittle while ago about my ss converson. I was giving it another go and I noticed that my rear wheel was still off center, I guess I didn't get the dish right. The trouble is that the spokes are bottoming out on the right side, I was going to rebuild the wheel (I have built about 6 - 10 years ago, little rusty!)so I checked a number of sites w/ spoke calc., I am getting some diff. lengths and was wondering the best way to proceed? Sometimes the diff. is 1 mm/1.5mm.
rim-549
hub dia.-45
center to flange-27
x3 - 36h
Thanks once again,
Greg