Cyclocross - Would you recommend a cross fork for this road bike?

Bikeforums.net is a forum about nothing but bikes. Our community can help you find information about hard-to-find and localized information like bicycle tours, specialties like where in your area to have your recumbent bike serviced, or what are the best bicycle tires and seats for the activities you use your bike for.



PDA
darksiderising
10-30-08, 06:08 PM
I replaced the fork on this repainted Univega Nuovo Sport a while ago, but I am not happy with the clearances it allows me, especially now that I want to use it for a utility/cross bike. The frame is designed for 27 inch wheels, but the wheels and fork I have on there now are 700c. I am trying to determine if I should get a cross fork (probably Surly Crosscheck, and I'll need a threadless headset) and some cantis for extra stopping power, especially if I am going offroad, or if I should just get a 27 inch fork. I will be running 700c wheel either way. I through my cross wheel in the rear and it had clearance for the 34mm width tire and a fender. I'd like the ability to put cross tires on, and I imagine that a 27 inch fork would fit the tire fine.

What do you think?

http://img514.imageshack.us/img514/5443/1004357gt8.jpg
http://img296.imageshack.us/img296/4513/1004358gz9.jpg

justinb
10-30-08, 06:22 PM
A 27" fork (what the frame was designed around) would have something in the neighborhood of a 390mm axle-to-crown length, and most CX forks are somewhere in the 400mm range. This isn't a huge change, but will slow the handling a little bit (or maybe quite a bit, versus the 700c road fork you currently have). This isn't all bad, it could improve the stability, a beneficial characteristic for your intended use.
darksiderising
10-30-08, 07:36 PM
I was thinking that relaxing the geometry would be beneficial for cross/rugged/town use.

justinb
10-31-08, 03:22 PM
I agree about relaxing the geometry. It will also aid stability when carrying a load. Beyond getting a longer axle to crown, you can also do this by decreasing the rake.

Your next problem is finding a cross fork that's 1 inch. There is the Cross Check fork, but that will mean a new headset and stem as well, since it's threadless. Tange or Dimension may make an inexpensive chromoly threaded cross/touring fork that fits your needs well.
zzyzx_xyzzy
10-31-08, 04:18 PM
I agree about relaxing the geometry. It will also aid stability when carrying a load. Beyond getting a longer axle to crown, you can also do this by increasing the rake.

Increasing the rake makes for faster/less stable handling (because it reduces trail.)
justinb
10-31-08, 05:16 PM
Increasing the rake makes for faster/less stable handling (because it reduces trail.)


Right you are. Sorry for adding to the confusion on an already confusing subject.