Mountain Biking - Klein internal cable routing-HELP
Bikeforums.net is a forum about nothing but bikes. Our community can help you find information about hard-to-find and localized information like bicycle tours, specialties like where in your area to have your recumbent bike serviced, or what are the best bicycle tires and seats for the activities you use your bike for.
12-12-08, 11:36 PM
OK how do I get a new shifter cable routed when the plastic liner is popped out....2003 Attutude with internal routing...Magnets? Aliens? cut the frame and re-weld it:lol:
12-13-08, 12:06 AM
I have used solid wire roughly the same diameter as your cables. Hardware stores or hobby shops carry the wire, usually called piano wire. Once you get the end through, tape your cable to the end and pull through the frame.
12-13-08, 12:52 AM
I use safety wire for wiring grips and bolts from a Motorcycle shop.
12-16-08, 08:36 PM
just push the cable through and when it gets to the other hole just fish it out with the j of a spoke...or make something similar to that
12-17-08, 12:43 PM
Run a string down the inside of the frame and pull it out the other end with a vacuum cleaner.
12-28-08, 11:15 AM
I have used a wire coat hanger. Bend it straight and then bend the front half inch down at about a 45 degree angle (aprox) tape the cable to the other end and fish her through. The angled tip will make it easier to find the hole from the inside.
Powered by vBulletin® Version 4.1.12 Copyright © 2014 vBulletin Solutions, Inc. All rights reserved.