Bikeforums.net is a forum about nothing but bikes. Our community can help you find information about hard-to-find and localized information like bicycle tours, specialties like where in your area to have your recumbent bike serviced, or what are the best bicycle tires and seats for the activities you use your bike for.Hasek
01-25-09, 10:59 AM
I got a set of Kool Stop Supra 2's for my Tektro cantilever brakes. I can't seem to get them set up properly. With the threaded stud from the pad at the lowest point on the Tektro brake mount slot (brake arm), the pads touch the rim barely below the tire. I measured the pads I am replacing and it was a 4mm spacing. I initially set up the Kool Stops at 4mm, according to the diagram below. I then also tried the 3mm and 5mm which neither worked.
What I do believe the problem is that the 3 or 5mm spacers don't slide down below the "special anti-slip base" shown in the diagram. This base essentially puts another 1/4 inch of space in.
Any help would be greatly appreciated.
What I do believe the problem is that the 3 or 5mm spacers don't slide down below the "special anti-slip base" shown in the diagram. This base essentially puts another 1/4 inch of space in.
Any help would be greatly appreciated.