Singlespeed & Fixed Gear - Brake Lever routing for Profile Stoker Bullhorn

Bikeforums.net is a forum about nothing but bikes. Our community can help you find information about hard-to-find and localized information like bicycle tours, specialties like where in your area to have your recumbent bike serviced, or what are the best bicycle tires and seats for the activities you use your bike for.



PDA
modmon
08-04-04, 02:32 PM
i have a set of el toros on my beater that have routing holes right near the end of the bars making cables look less noticable but the profile stoker bullhorns i have for my rush arent set up like that. instead of having a hole near the end of the bars, there are two holes on the side of the bars. the holes look like outs so i was wondering if there are any levers that run the cables directly inside the bar ends. if so, who makes them?

stronzo
08-04-04, 02:34 PM
i know syntace space control levers route directly into the bar (have a pair).
g_taco
08-04-04, 06:56 PM
i have a set of el toros on my beater that have routing holes right near the end of the bars making cables look less noticable but the profile stoker bullhorns i have for my rush arent set up like that. instead of having a hole near the end of the bars, there are two holes on the side of the bars. the holes look like outs so i was wondering if there are any levers that run the cables directly inside the bar ends. if so, who makes them?

Can't you just drill a hole at the end where you want it? Strength is not an issue at the end, and aluminum is easly to drill.
As far the levers that run cables inside, syntace space control ones do. I have them and they are very ergonomic. The levers have a bend in the middle which makes the ends position where you want them.