BMX - new handlebars
Bikeforums.net is a forum about nothing but bikes. Our community can help you find information about hard-to-find and localized information like bicycle tours, specialties like where in your area to have your recumbent bike serviced, or what are the best bicycle tires and seats for the activities you use your bike for.
08-09-04, 12:38 AM
hey im lookin for some shorter handlebars, i was lookin into the S&M Dive bars, does ne one know if there good or know any better brands with a short bar, pref. 24"
08-09-04, 12:18 PM
If you want bars that aren't wide, then just cut your bars. I usually use a tube cutter from my local hardware store, but if you are careful you can use a hacksaw. Just make sure to file any rough edges when you are done and don't cut off more than an inch from either end at a time so you can figure out what width you like best. It's easy to take off bar from the ends... a lot tougher to put it back on.
08-09-04, 04:20 PM
thanks a lot man
Powered by vBulletin® Version 4.1.12 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.