Framebuilders - Brazed Fat Tire Fixed Gear (or a short wheelbase 29er)
Bikeforums.net is a forum about nothing but bikes. Our community can help you find information about hard-to-find and localized information like bicycle tours, specialties like where in your area to have your recumbent bike serviced, or what are the best bicycle tires and seats for the activities you use your bike for.
03-18-10, 09:54 PM
Here are some pictures of a project I have been planing for the last few months. My father and I started the work on tuesday and hope to finish up tomorrow.
03-18-10, 09:55 PM
03-18-10, 09:56 PM
ran out of oxygen after the chainstays were finished. seatstays will be done in the morning.
03-18-10, 11:35 PM
interesting fixturing -- I like it. I'll be interested in knowing how that seat tube/down tube joint holds up. It looks like the cleanup might have been a little heavy-handed. You really don't want to cut into the tubes at all.
03-19-10, 12:19 AM
that st/dt joint is actually really solid, possibly still bulky. that last pic its just covered in a film of flux and afterburn from the chainstays
03-19-10, 12:49 AM
not talking about the brazing, that looks ok.
I see what the confusion is on my previous post. The heavy-handed cleanup I was talking about was the downtube/head tube joint.
rodar y rodar
03-19-10, 01:36 AM
The plywood angle plate looks like a good idea. Top tube is pierced by the seat tube? Cool! Don`t think I`ve seen that one before.
03-19-10, 04:13 PM
14 bike co does pierced seat tubes on their freestyle fixed bikes
03-28-10, 07:46 PM
rodar y rodar
03-28-10, 09:56 PM
Looking good! You painted it yourself, too? And it`s going to stay single speed? I can`t tell for sure, but in one of your earlier pics (bike leaning against a toolbox with no seat stays yet) it looks like a derailler hanger.
Powered by vBulletin® Version 4.1.12 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.