Bikeforums.net is a forum about nothing but bikes. Our community can help you find information about hard-to-find and localized information like bicycle tours, specialties like where in your area to have your recumbent bike serviced, or what are the best bicycle tires and seats for the activities you use your bike for.D.J.M.
08-12-10, 05:05 PM
I just installed new bearings on the hub of my Zipp wheel with a 182 hub.
However, when I spin the wheel on the axle, without mounting it on the bike, it does not spin freely for as long as I'd think normal would be.
It does spin more than before I replaced the worn out bearings (the drive side bearing was considerably more worn than the NDS bearing).
I have tightened the axle to the recommended 10nm.
What can be the cause of the wheel not spinning freely?
Thanks to any responders :thumb:
However, when I spin the wheel on the axle, without mounting it on the bike, it does not spin freely for as long as I'd think normal would be.
It does spin more than before I replaced the worn out bearings (the drive side bearing was considerably more worn than the NDS bearing).
I have tightened the axle to the recommended 10nm.
What can be the cause of the wheel not spinning freely?
Thanks to any responders :thumb: