Winter Cycling - DIY studs question
Bikeforums.net is a forum about nothing but bikes. Our community can help you find information about hard-to-find and localized information like bicycle tours, specialties like where in your area to have your recumbent bike serviced, or what are the best bicycle tires and seats for the activities you use your bike for.
12-08-10, 12:49 AM
I have made a set of studded tyres.They work very well:thumb:.How low should i let the studs wear down before i replace it?
12-08-10, 12:54 AM
Until they stop working.
Just retired a tyre after 15,000 plus km and 10 years as the casing and tread were actually degrading while the studs were still fine.
12-08-10, 01:17 AM
Ok,I`ll Keep riding till it gets a bit slippy,thanks.
12-08-10, 01:33 AM
The tyres I am running tonight have 5000km on them and still bite like a mad dog... :)
12-08-10, 05:49 AM
You could test it on some black ice.
Ive been thinking about wear rate and how easy it would be to replace all the screws. I dont think it is a major job, about 2 hrs.
Each screw head is backed by a cut out square of inner tube and these would have to be removed and reglued (using Copydex rubber adhesive). I tried gluing a whole inner tube in place but it is easier with smaller bits.
12-13-10, 02:53 AM
I have a second tyre with the bead cut off as a liner.Easier for re studding .;-)
Powered by vBulletin® Version 4.1.12 Copyright © 2014 vBulletin Solutions, Inc. All rights reserved.