Framebuilders - First
Bikeforums.net is a forum about nothing but bikes. Our community can help you find information about hard-to-find and localized information like bicycle tours, specialties like where in your area to have your recumbent bike serviced, or what are the best bicycle tires and seats for the activities you use your bike for.
View Full Version : First
06-14-12, 09:09 PM
Been sitting on this awhile now...my first frame recently back from powder coat and built up. Nothing fancy, just very large (if the top tube were horizontal it would be a 66cm frame.) Built with a torch, some files, a bench clamp, some chunks of angle iron, and a magnetic protractor. Also a few choice words here and there. Proud to say that it came out very straight, aligned within a millimeter via string method at the seat tube, and rides very nicely, stable at low and high speeds. Best road frame I've ridden that actually fit me!
Pretty much taught myself how to do this by scouring this forum for a few months and reading the free version of Paterek, then jumped in. Had a lot of fun problem solving due to not having a lot of the specialized tools or a jig available.
Anyway, big thanks to everyone past and present here whose knowledge I gleaned!
06-16-12, 07:36 PM
Congratulations. That thing looks fantastic. I've wanted to jump into frame building for awhile now but I've been scared off by some of the professional's comments. Do you have any tips for a first time builder?
06-16-12, 08:26 PM
that looks really good, thanks for posting pictures
06-18-12, 09:44 AM
Biggest tip is don't be scared! I believe if you read enough, think carefully, and go slow, anyone can end up with a straight, rideable bike using minimal tooling. At least as good as an off the shelf frame, but with the benefit of having enjoyed the process of making it. Keep in mind that despite the way frame building gets talked about, these things don't need to be built to aerospace tolerances. In the end, its "just" a bicycle.
I found this little clip really inspiring when I was teaching myself:
The part at 3:20 when he checks alignment of the seat and headtubes by eyeball....super accurate and completely free. They don't need no stinking jig or new fangled alignment table!:p
06-18-12, 05:40 PM
I built a frame or two using the eyeball the ht/st alignment method. Of course, you also have to check that the DT is parallel to the sides of the BB shell or you have real problems. There was a post from someone on the framebuilders email list that said he used that method for his first 100 frames. It's really slow, and you have to be meticulous, and you still might end up with a crooked frame, so it's not for everyone. OTOH, you can easily end up with a crooked frame if you rely on your fixture too much, so there's that to consider as well.
Unfortunately, I can't use this method anymore, eyes are bad.
Andrew R Stewart
06-18-12, 09:58 PM
If you don't spin out when doing parking lot auto cross you don't learn... Some of the issue i have with this interweb frame discussion is the lack of allowing to make a mistake.
Aligning a bike during the build has a number of methods that all, if done well, can produce a well riding bike. As many have said before, it's how you use your tools, not which tools you own. Andy.
Powered by vBulletin® Version 4.1.12 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.