Forums

Bicycle Mechanics - Bicycle Mechanic Wanted

Bikeforums.net is a forum about nothing but bikes. Our community can help you find information about hard-to-find and localized information like bicycle tours, specialties like where in your area to have your recumbent bike serviced, or what are the best bicycle tires and seats for the activities you use your bike for.

PDA

View Full Version : Bicycle Mechanic Wanted

Trailrider54

01-26-05, 08:35 PM

My partner and I are in the early stages of opening a Pro Mountain Bike Shop in Atlanta Georgia (South Side)

We are looking for a mechanic with at least 2 Years experience.
However I would consider someone with 1 year, if there experience is extensive enough.

Thank you for your time

W. Young
Atlanta Pro MTB

Bike_13

01-26-05, 09:39 PM

Dirtbike

01-26-05, 10:29 PM

roadfix

01-27-05, 12:21 AM

Here's a better idea: If an applicant is not on time for his/her scheduled interview, don't waste your time. Go to your next applicant.

ZenNMotion

01-27-05, 09:14 AM

Good luck! In my opinion - test all applicants - hand them a hub, a rim, and the WRONG LENGTH SPOKES and ask them to build the wheel.

If they measure the spokes first - interview them.

If they just start building the wheel - thank them kindly and keep looking.

...Or if they measure the spokes, see that they're a little off and they figure out how to build a rideable wheel anyway then hire them.
http://www.bikeforums.net/showthread.php?t=84848

But seriously for an all-around (not just a new bike assembler), I'd test them on

Servicing/adjusting suspension forks (a couple different brands and types)
Checking frame alignment
Servicing disc brakes
Optimising canti brakes
Install a threaded headset and fork
True a wheel with a bad hop
Build a rear road race wheel with an assymetric rim- calculate spoke length, (radial non-drive side?) and adjust for proper tension
replace bearings on cone/race hub
... and dealing politely with 15 year old customers with lots of questions all at the same time

Trailrider54

01-27-05, 09:45 PM

Thanks for all the great advise, we hope to be open before June 2005

Later

W Young
Atlanta Pro MTB

gruppo

01-27-05, 09:57 PM

Bike 13 - Your test/answer is valueless. What good would it do to measure the spokes? The only legimate response would be for the applicant to ask, "Are you sure these are the correct length spokes for this hub & rim and the lacing pattern you want?" You would then provide a spoke length calculator tool, and say, "I think so, but why don't you double check it."