Bikeforums.net is a forum about nothing but bikes. Our community can help you find information about hard-to-find and localized information like bicycle tours, specialties like where in your area to have your recumbent bike serviced, or what are the best bicycle tires and seats for the activities you use your bike for.europa
12-17-12, 03:33 AM
Currently trying to fit a modern brake to 27" forks wearing a 700c wheel. Naturally, they don't reach and the old diacompe currently being used is right up there with dragging your shoe on the front tyre.
Options include buying new forks or buying a long reach front brake - both are pricey in this country and I don't really have the money to spend on this bike anyway.
Now, bearing in mind that I already have a pair of rather nice dual pivot brakes, and I don't have any money, I'm looking at making a mount to lower the caliper.
Has anyone done this?
I'm thinking along the lines of mounting a piece of 2mm steel strapping front and rear of the fork using the existing mounting holes. The caliper's mounting bolt will go just under the fork bridge so I shouldn't have problems with that bolt pulling the strapping together - not hard to fit a spacer if I do. Done neatly, it shouldn't look too bad.
Any thoughts or experiences?
Options include buying new forks or buying a long reach front brake - both are pricey in this country and I don't really have the money to spend on this bike anyway.
Now, bearing in mind that I already have a pair of rather nice dual pivot brakes, and I don't have any money, I'm looking at making a mount to lower the caliper.
Has anyone done this?
I'm thinking along the lines of mounting a piece of 2mm steel strapping front and rear of the fork using the existing mounting holes. The caliper's mounting bolt will go just under the fork bridge so I shouldn't have problems with that bolt pulling the strapping together - not hard to fit a spacer if I do. Done neatly, it shouldn't look too bad.
Any thoughts or experiences?