lala
02-17-05, 08:05 AM
Anyone have an idea what a framebuilder might charge to do this?
General Cycling Discussion - Adding canti bosses to a steel frame
Bikeforums.net is a forum about nothing but bikes. Our community can help you find information about hard-to-find and localized information like bicycle tours, specialties like where in your area to have your recumbent bike serviced, or what are the best bicycle tires and seats for the activities you use your bike for.View Full Version : Adding canti bosses to a steel frame
Shifty
02-17-05, 08:30 AM
Brazing is not expensive, they will charge you on an hourly rate plus the parts. The job will involve prep work, grinding off paint and clean, and then brazing would be done next. I guess it would be a bit less than an hour to do, lot of shops will have a minimum shop rate. If you have them paint, you'll need to add that on too.
I had some braze work done a few years ago in C,Springs, Old Town Bike Shop, John Crandell helped me with it. You might also call Barnett School for advise or referal.
Hope this helps.
I had some braze work done a few years ago in C,Springs, Old Town Bike Shop, John Crandell helped me with it. You might also call Barnett School for advise or referal.
Hope this helps.
lala
02-17-05, 10:06 AM
Thanks, Shifty. That helped alot! I might get a deal on a sweet mtb frame, but it is disc only...and I want to run v-brakes.