Gouges in aluminum frame - how to repair properly?
#1
Senior Member
Thread Starter
Join Date: Jul 2011
Posts: 138
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Gouges in aluminum frame - how to repair properly?
Hey guys, I plan on powdercoating this frame but am concerned about the effects of the deep scratches that occurred to the top tube. Is there a proper way to take care of these deep pits prior to powdercoating? I'd do a bondo solution but am afraid that it will not hold up after 10 years and in the oven. Or should I just deal with it by smoothing it out and powdercoat over it?
Thanks!
Note: you can right-click and open the picture into a new tab to see the full sized image.
Thanks!
Note: you can right-click and open the picture into a new tab to see the full sized image.
#2
Senior Member
Join Date: May 2005
Location: La La Land (We love it!)
Posts: 6,301
Bikes: Gilmour road, Curtlo road; both steel (of course)
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
Quoted: 273 Post(s)
Likes: 0
Liked 10 Times
in
9 Posts
The biggest danger of gouges like that is possible stress risers.
Filing the area smooth will eliminate that as well as make it look the way you want...
Filing the area smooth will eliminate that as well as make it look the way you want...
__________________
Today, I believe my jurisdiction ends here...
Today, I believe my jurisdiction ends here...
#3
Senior Member
Join Date: Apr 2006
Posts: 3,653
Mentioned: 13 Post(s)
Tagged: 0 Thread(s)
Quoted: 380 Post(s)
Likes: 0
Liked 106 Times
in
80 Posts
You can't really repair the gouges if you are going to powder coat it. Anything you would put on there has to metal for the powder to stick. Part of powder coating it is baking the powder to get the gloss and that would take off most fillers. Sand as smooth as you can and live with it. Roger
#4
Senior Member
Join Date: Mar 2010
Location: City of Brotherly Love
Posts: 1,562
Bikes: Raleigh Companion, Nashbar Touring, Novara DiVano, Trek FX 7.1, Giant Upland
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 22 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
You might want to try Alvin Hi-Temp Lab-metal.
Thread
Thread Starter
Forum
Replies
Last Post
Syncmaster
Bicycle Mechanics
15
09-25-13 09:01 PM