frog levers i cant get them to work again after losening
#1
Junior Member
Thread Starter
Join Date: May 2005
Posts: 20
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
frog levers i cant get them to work again after losening
Hi. I recently got back from a flight with my bike so I had to loosen the front brake cable to twist the handlebars into box position.
Now I tried putting them back on and i cant get them to work. Basically my problem is if I put them on loose the cable is too loose to pull the brake pads up. If I put them on tight, the cable kinda scrunches in the middle against the 2 cable seperator and still doesnt pull the pads up. Anyone know what I mean? got a solution?
Now I tried putting them back on and i cant get them to work. Basically my problem is if I put them on loose the cable is too loose to pull the brake pads up. If I put them on tight, the cable kinda scrunches in the middle against the 2 cable seperator and still doesnt pull the pads up. Anyone know what I mean? got a solution?
#2
Junior Member
Thread Starter
Join Date: May 2005
Posts: 20
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
its ok i found out what I was doing wrong. I was supposed to clip the top part into the fixed place on the bar. I had both cables moving around freely. Probably makes little sense