need some crank help
#1
Senior Member
Thread Starter
Join Date: Feb 2006
Location: PA
Posts: 213
Bikes: many
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
need some crank help
i have recently replaced a crank bearing in my schwinn, i replaced it becuase the old bearing got chewed up because i got sand in there. But now everytime i tighen up the crank so that the rod or w/e the pedals connect to doesnt have free play it spins fine but it somtimes has a little tention then goes fine, is this a hint of more grease or what?
#2
Senior Member
Join Date: Feb 2004
Location: St Peters, Missouri
Posts: 30,225
Bikes: Catrike 559 I own some others but they don't get ridden very much.
Mentioned: 16 Post(s)
Tagged: 0 Thread(s)
Quoted: 1572 Post(s)
Liked 643 Times
in
364 Posts
Tell us more about the rest of the bike. Are you checking the bearing preload with the chain disconnected?
#3
Senior Member
#4
Senior Member
Thread Starter
Join Date: Feb 2006
Location: PA
Posts: 213
Bikes: many
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Originally Posted by Retro Grouch
Tell us more about the rest of the bike. Are you checking the bearing preload with the chain disconnected?
#5
Senior Member
Thread Starter
Join Date: Feb 2006
Location: PA
Posts: 213
Bikes: many
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Originally Posted by Matt Gaunt
Check the bearings, not the cranks. This often happens when you've been rawming with the cranks.