cuda2k

I have a 531c steel frame that I'm wanting to put a new (possibly CF) seat post in. However when I put the current alloy post in there it was a very very tight fit with significant rough spots near the clamp. I did what I could at the time to smooth it with some sand paper to get the post inserted, but I know I put some deep scratches in that post. Before I buy a new, nicer, post, especially if it is carbon, I want it to go in with minimal damage.

So, where should I take it, can the LBS do this kind of work, or would a frame shop be a better bet?

I_bRAD

I'm not sure if the LBS has the tools or not, but any machine shop can do it for sure.

Also- Go with the Thomson and you'll be much happier anyhow

TallRider

I've cleaned out seat tubes on old Schwinn frames (that came stock with a shim) using small pieces of sandpaper operated by my forefinger. Try this first - takes 5-10 minutes and costs next to nothing. I've also used a file to run up and down the tube, all the way around the inside of the tube, which will take off anything that sticks up above the rest.

roadfix

Yep, finger and sandpaper method have always worked for me...

well biked

Cuda, I agree with the above about trying sandpaper first, but if it turns out you need a good frame shop, since you're in Dallas, David at www.southwestframeworks.com is someone you might contact, he's a very nice guy and he treated me right on some repair work not long ago. And actually, I think most bike shops can ream seat tubes-

cuda2k

well biked: that's the shop I was thinking of, and planning to take the frame to in the spring for a full repaint. Lotek speaks highly of the shop as well, glad to hear of another good review.

I did the sand paper routine fairly extensively when I first assembled the bike. Suppose I could give it another go when I'm ready to swap posts.