Spoke diameter question
12-04-06, 09:32 PM
#1
lunatic fringe
Thread Starter
Join Date: Aug 2005
Location: Miles from Nowhere, Columbia County, OR
Posts: 1,111
Bikes: 1980 Schwinn World Sport, 1982 Schwinn Super Le Tour, 1984 (?) Univega Single Speed/Fixed conversion, Kogswell G58 fixed gear, 1987 Schwinn Super Sport
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 1 Time
in
1 Post
Spoke diameter question
I am considering using Wheelsmith DH13 spokes with a White Industries ENO hub. The spoke diameter is 2.3.. and the hole is 2.5. Does anyone know if there is enough room to get the spokes "around the corner" of the flange without drilling them out?
Thanks,
Thanks,
12-05-06, 07:11 PM
#2
Senior Member
Join Date: Feb 2004
Location: St Peters, Missouri
Posts: 30,225
Bikes: Catrike 559 I own some others but they don't get ridden very much.
Mentioned: 16 Post(s)
Tagged: 0 Thread(s)
Quoted: 1572 Post(s)
Liked 643 Times
in
364 Posts
DT says their 2.34mm spokes will fit a hub that has 2.5mm or larger spoke holes.
