brake pads issue
#1
3 summits of Athens
Thread Starter
Join Date: Aug 2005
Location: Athens
Posts: 335
Bikes: SCOTT AFD/KLEIN MANTRA/BMC SSX Streetfire
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
brake pads issue
Hello guys, have a happy new year,not only on your bikes i hope..
I've been trying for hours to remove worn out brakepads (ultegra,rear brake) but the damn thing won't slide an inch! First time i'm facing such a stubborn s$$t. Bottomline is i'm grubing it to chips with a screwdriver and can't figure out how scorched it's ended up. Any better ideas? Thanks, regards.
I've been trying for hours to remove worn out brakepads (ultegra,rear brake) but the damn thing won't slide an inch! First time i'm facing such a stubborn s$$t. Bottomline is i'm grubing it to chips with a screwdriver and can't figure out how scorched it's ended up. Any better ideas? Thanks, regards.
#3
Senior Member
Join Date: Aug 2005
Location: Pittsburgh, PA
Posts: 33,656
Bikes: '96 Litespeed Catalyst, '05 Litespeed Firenze, '06 Litespeed Tuscany, '20 Surly Midnight Special, All are 3x10. It is hilly around here!
Mentioned: 39 Post(s)
Tagged: 0 Thread(s)
Quoted: 2026 Post(s)
Likes: 0
Liked 1,095 Times
in
741 Posts
Are these insert pads that slip into (and out of) pad holders or are they the older design where the pads and its holder are one bonded assembly and replaced as a complete unit? You may be trying to disassemble something that isn't supposed to be.