Cycling and bicycle discussion forums. 
   Click here to join our community Log in to access your Control Panel  

Go Back   > >

Bicycle Mechanics Broken bottom bracket? Tacoed wheel? If you're having problems with your bicycle, or just need help fixing a flat, drop in here for the latest on bicycle mechanics & bicycle maintenance.

User Tag List

Thread Tools Search this Thread
Old 03-29-07, 12:17 PM   #1
Back in the Sooner State
Thread Starter
Join Date: Aug 2002
Location: Norman, OK
Posts: 2,572
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Internal cable routing on Profile aero bars

I have a new set of T2+ clip on bars from Profile and I'm trying to figure out how the shift cables run through them. There is a hole on each of the bars on top, and another on the bottom. Should the cables run out of the back of the bars somewhere near the elbow pads? Where do I run my housing?
ImprezaDrvr is offline   Reply With Quote
Old 03-29-07, 12:40 PM   #2
Join Date: Sep 2004
Posts: 30
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
It depends which way up you prefer your shifters (top or bottom hole)
if the plug for the back of the bar has a slot in it then the cable is supposed to run all the way through, you should trim the bars if they extend too far back because the cables will have to make a sharp bend.

or just put the cables under the tape and do not internally route them at all.
neutron7 is offline   Reply With Quote

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -6. The time now is 11:11 PM.