aftermarket Jockey Wheels
#1
Senior Member
Thread Starter
aftermarket Jockey Wheels
I am looking to replace both pulleys on my D/A 7800 RD. I was looking at the KCNC aluminum ones.
Can someone tell me if the upper and lower wheel are interchangeable? Should the pulleys carry separate part number's or one pulley fits both?
Can someone tell me if the upper and lower wheel are interchangeable? Should the pulleys carry separate part number's or one pulley fits both?
__________________
BMC Roadmachine
Kona Jake the Snake
BMC Roadmachine
Kona Jake the Snake
#2
Boomer
Join Date: Nov 2003
Posts: 7,214
Bikes: Diamondback Clarity II frame homebuilt.
Mentioned: 106 Post(s)
Tagged: 0 Thread(s)
Quoted: 16098 Post(s)
Liked 1,457 Times
in
1,064 Posts
Same pully both locations. The upper pully is installed with no or thinner washers so as to float back and forth just a little.
While this provides some bling, you may find no improvement in performance at all for the money they cost.
While this provides some bling, you may find no improvement in performance at all for the money they cost.
__________________
#4
Senior Member
Thread Starter
I have almost 20,000 miles on the stock ones so there must be some wear on them. Figure a little bling while I do the spring maintenance would be nice..
__________________
BMC Roadmachine
Kona Jake the Snake
BMC Roadmachine
Kona Jake the Snake