Who makes a 123mm isis drive bottom bracket?
08-02-08, 09:08 PM
#1
coffee bean grinder
Thread Starter
Join Date: Jul 2005
Posts: 526
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Who makes a 123mm isis drive bottom bracket?
I have a 113mm, and it is 5mm short (drive side) to get the right chainline and clearance of the seatstay.
Most of the ISIS BB manufacturers only have 118mm, anyone has one with about 123mm spindle length?
thansk.
Most of the ISIS BB manufacturers only have 118mm, anyone has one with about 123mm spindle length?
thansk.
Last edited by grinderbob; 08-02-08 at 09:19 PM.
08-02-08, 09:26 PM
#2
Senior Member
Join Date: Jul 2007
Location: Vangroovy, BC
Posts: 379
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
If you find a NDS BB cup that will fit inside a 68mm shell(I'm assuming you have a 68 because there are plenty of 123x73 ISIS BB's out there) you'll be fine. There just needs to no outer lip to the cup and it needs to be able to sit flush with the BB shell. I've done this with customer bikes at the shop I work at and I have yet to have any issues with it.
08-02-08, 09:40 PM
#3
coffee bean grinder
Thread Starter
Join Date: Jul 2005
Posts: 526
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
yes, it is a 68mm shell. on the drive side, I think I can use a 118mm and add a 2.5mm spacer, but not sure
how to do it on the non-drive side. (I'm talking about BB using cups, not flanges).
how to do it on the non-drive side. (I'm talking about BB using cups, not flanges).
