Removing Giant OCR fork races
#1
affix pistol bayonets!
Thread Starter
Join Date: Sep 2006
Location: Milwaukee
Posts: 252
Bikes: Early-Mid 80's Peugeot Super Competition, 1981 Basso, Mid-80's Peugeot Course
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Removing Giant OCR fork races
Hey guys. I'm trying to replace the crown race on a Giant OCR's carbon fork but can't figure out a way to get a hold of it. I have a new headset that I'm trying to install, but the original race that came on the fork seems to be semi-permanently attached. There is no way to get at it with a lever to lever it off and the only way I could see removing it is by cutting it off and sliding the new one over the steerer tube.
Last edited by mediccody; 02-13-09 at 01:47 PM.
#2
mechanically sound
Try to find a shop with a race remover. Our shop has one(park), and it's pretty slick for a huge, expensive device that only performs one small task.
#3
affix pistol bayonets!
Thread Starter
Join Date: Sep 2006
Location: Milwaukee
Posts: 252
Bikes: Early-Mid 80's Peugeot Super Competition, 1981 Basso, Mid-80's Peugeot Course
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
This crown race sits flush against the top of the fork crown without any gaps, holes, or notches to grab on. We've used crown race removers but they don't seem like they would work. Would this https://www.parktool.com/products/det...51&item=CRP-1# work for an otherwise inaccessible crown race?
#4
Senior Member
it should. it make to remove all races.
#5
mechanically sound
If the park puller won't work, I don't think any non-destructive method will.
#6
Senior Member
Join Date: Aug 2005
Location: Pittsburgh, PA
Posts: 33,656
Bikes: '96 Litespeed Catalyst, '05 Litespeed Firenze, '06 Litespeed Tuscany, '20 Surly Midnight Special, All are 3x10. It is hilly around here!
Mentioned: 39 Post(s)
Tagged: 0 Thread(s)
Quoted: 2026 Post(s)
Likes: 0
Liked 1,095 Times
in
741 Posts
The Park crown race remover is basically a modified "bearing splitter" that forces very thin wedges between the crown race and the forks' race seat and pries the crown race up from the sides. It works when there is no edge of the crown race overlapping the seat so a typical remover is useless.