kmc X10SL on SRAM?
#1
Senior Member
Thread Starter
Join Date: May 2007
Location: New York metro area
Posts: 458
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 1 Time
in
1 Post
kmc X10SL on SRAM?
Anyone have experience with KMC X10sl chain on SRAM red? I'm trying it and having strange issues. It runs smoothly except that on the 13 cog (3rd smallest on an 11-26 cassette) it skips like crazy under load (while on either the big or small chain ring). On the 11-26 the 13 cog is the smallest on the 1 piece cone. Runs fine on 14, 12, 11, and remainder cogs under any load. Any ideas on what the problem is?
#2
Zircon Encrusted Tweezer
Join Date: May 2004
Location: Marshfield, MA
Posts: 1,016
Bikes: Pivot Switchblade, SantaCruz Tallboy, SantaCruz Solo, Specialized Fatboy, Trek ProjectOne Madone, Fuji Altamira CX 1.1, Lemond Zurich
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 1 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
I run the same setup and have no problems with it. If all the parts are relatively new, and the derailleur is adjusted properly, it could be your derailleur hanger is a bit out of alignment.
#4
Senior Member
Join Date: Feb 2009
Location: Austin, TX
Posts: 208
Bikes: Giant XTC Team Custom XC bike, Nashbar tourer custom commuter
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Could there be a problem with that cassette sprocket? Perhaps a chip, bend, or additional piece of something?