Installing a handlebar shim. . .
#1
Senior Member
Thread Starter
Join Date: Dec 2004
Location: Brooklyn, NY
Posts: 293
Bikes: 2011 Cannondale CAAD 10, Moser "Special", RIP- early/mid 90's Zullo "Sprint" (ultegra grouppo, stronglight crankset), 04 Bianchi Pista (stock except for the saddle, front break and pedals)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Installing a handlebar shim. . .
I'm trying to put a 25.4-->26.0 shim on my handlebars and I can't seem to figure out a good way to get it in there. I have a quill stem that doesn't have a removable faceplate. Any tips or suggestions?
#2
Senior Member
Join Date: Aug 2005
Location: Pittsburgh, PA
Posts: 33,656
Bikes: '96 Litespeed Catalyst, '05 Litespeed Firenze, '06 Litespeed Tuscany, '20 Surly Midnight Special, All are 3x10. It is hilly around here!
Mentioned: 39 Post(s)
Tagged: 0 Thread(s)
Quoted: 2026 Post(s)
Likes: 0
Liked 1,095 Times
in
741 Posts
Install the handlebars and center them. Then expand the gap in the stem to create more clearance and slip the shims in place. With some stems you can expand the gap by installing the clamp bolt backwards and insert a washer or penny for the bolt to press against. With other you have to wedge something into the gap to make the clamp temporarily larger.
#3
Senior Member
Thread Starter
Join Date: Dec 2004
Location: Brooklyn, NY
Posts: 293
Bikes: 2011 Cannondale CAAD 10, Moser "Special", RIP- early/mid 90's Zullo "Sprint" (ultegra grouppo, stronglight crankset), 04 Bianchi Pista (stock except for the saddle, front break and pedals)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts