Problems patching 20-28mm tubes?
#1
Senior Member
Thread Starter
Join Date: Nov 2008
Location: Hollister, CA
Posts: 3,957
Bikes: Volagi, daVinci Joint Venture
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 3 Times
in
2 Posts
Problems patching 20-28mm tubes?
Anyone using 20-28mm tubes in their 28mm tires ? I'm a bit concerned about the amount of stretch required of the tube. The patches I'm using don't appear to stretch and I've just had a patch fail. My LBS doesn't carry 25-28mm tubes, but these are available online albeit I haven't found a cheap source.
Anyone else experienced a failure that they attributed to excessive stretch of the tube versus patch?
FWIW, I'm using Specialized tubes.
Anyone else experienced a failure that they attributed to excessive stretch of the tube versus patch?
FWIW, I'm using Specialized tubes.
#2
Senior Member
If the patch is put on properly it shouldn't come off. Make sure that the mold release is sanded off and let the glue dry for at least 5 minutes.
#3
Senior Member
Join Date: Oct 2005
Location: Fresno, CA
Posts: 4,454
Mentioned: 6 Post(s)
Tagged: 0 Thread(s)
Quoted: 128 Post(s)
Likes: 0
Liked 12 Times
in
10 Posts
I use 18-25mm tubes in my 28mm tires, have a couple of patches, no problem. Note that these are vulcanized rubber patches (the traditional kind), not instant stick-on patches with which most people don't have good luck (though a few have had consistent success).
__________________
"c" is not a unit that measures tire width
"c" is not a unit that measures tire width