brake performance with new Weinmann wheelset
01-08-10, 07:12 PM
#1
Newbie
Thread Starter
Join Date: Jan 2010
Posts: 2
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
brake performance with new Weinmann wheelset
I recently replaced the wheelset on my old Ross road bike. The original rims were Araya laced to Schimano hubs. I wore these wheels out and recently replaced them with new Weinmann wheels. The brakes only function with about half the strength as with the original Araya rims. I tried new pads, but the braking did not improve. The new wheelset has kind of a silver matte finish the old Araya's were very shinny. Any insights appreciated
01-08-10, 07:54 PM
#3
Senior Member
Join Date: Jun 2007
Location: A Coffin Called Earth. or Toronto, ON
Posts: 12,257
Bikes: Bianchi, Miyata, Dahon, Rossin
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 3 Post(s)
Likes: 0
Liked 5 Times
in
5 Posts
either of these should help.
https://www.parktool.com/repair/readhowto.asp?id=20
https://www.parktool.com/repair/readhowto.asp?id=21
follow the guide that matches your brake type.
https://www.parktool.com/repair/readhowto.asp?id=20
https://www.parktool.com/repair/readhowto.asp?id=21
follow the guide that matches your brake type.
__________________
Food for thought: if you aren't dead by 2050, you and your entire family will be within a few years from starvation. Now that is a cruel gift to leave for your offspring. ;)
https://sanfrancisco.ibtimes.com/arti...ger-photos.htm
Food for thought: if you aren't dead by 2050, you and your entire family will be within a few years from starvation. Now that is a cruel gift to leave for your offspring. ;)
https://sanfrancisco.ibtimes.com/arti...ger-photos.htm
01-08-10, 08:16 PM
#4
Senior Member
Join Date: Jan 2007
Location: Silicon Valley, CA.
Posts: 662
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 1 Time
in
1 Post
Are the new rims' braking surface anodized? If yes, you need to wear off the anodizing layer before you can achieve maximum braking. To do that, either go for a wet, gritty ride or use some really coarse sandpaper to remove the anodizing layer. The wet ride ensures uniformity but the coarse sandpaper is good too as long as you don't concentrate too much effort on one particular spot. Regardless, once you have pad-to-aluminum contact, you'll good.
Last edited by Mr. Fly; 01-08-10 at 08:18 PM. Reason: grammar
