Tektro RL720 cross brake: Pin getting loose
#1
Senior Member
Thread Starter
Join Date: Mar 2007
Posts: 365
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Tektro RL720 cross brake: Pin getting loose
I've had these brakes for years and I've been noticing the pin that attaches the lever keeps moving up bit by bit. Well it's a lot now and I'm worried it will just fall off one day.
IMG00091-20100605-0&.jpg
Would someone please help on how to fix this?
IMG00091-20100605-0&.jpg
Would someone please help on how to fix this?
#4
Senior Member
Join Date: Aug 2005
Location: Pittsburgh, PA
Posts: 33,656
Bikes: '96 Litespeed Catalyst, '05 Litespeed Firenze, '06 Litespeed Tuscany, '20 Surly Midnight Special, All are 3x10. It is hilly around here!
Mentioned: 39 Post(s)
Tagged: 0 Thread(s)
Quoted: 2026 Post(s)
Likes: 0
Liked 1,095 Times
in
741 Posts
The pin must be lined up exactly with the holes in the body on both sides before it will drive in flush. Look at the hole on the opposite side and wiggle the pin until it is aligned properly and it should slip back in with little force. Once it's centered, replace and tighten the set screw.