Stiff bottom bracket
hi all,
Put my new frame together today and the bottom bracket is quite stiff. It's a Shimano R700 crankset and I used the bottom bracket that came with it. It turns ok, but doesn't spin freely and seems like it has a little resistance to it. Could it be that the grease is just a little dried out and will loosen with use? Thanks |
New Parts?
You may not notice it after a few weeks of riding on it, some seal friction likely .. lever of the crank is long.. |
Yeah, picked it up from a trusted vendor that I do business with.
|
No way to tell remotely what you mean by "it doesn't spin freely" but some resistance is to be expected on a new BB. If it does not feel outright rough and rotates with even resistance I would not worry about it. All bearings run better when broken in with some miles, as long as they are kept adjusted.
|
Bottom brackets these days are nothing like ye old days of cups and cones where you could spin the cranks with ease. With all the seals these days, they won't spin so freely. What matters is how they spin under load, and as long as that's fine there's no worry.
|
It spins and it's even. I've just never had one that was as stiff as this one. These are the outboard cup model so there is no adjustment. I'll put some miles on it and see how it goes. Worse case is I change them with the some known good one's that I have.
|
Originally Posted by knobster
(Post 11482169)
It spins and it's even. I've just never had one that was as stiff as this one. These are the outboard cup model so there is no adjustment. I'll put some miles on it and see how it goes. Worse case is I change them with the some known good one's that I have.
|
Originally Posted by knobster
(Post 11482169)
It spins and it's even. I've just never had one that was as stiff as this one. These are the outboard cup model so there is no adjustment. I'll put some miles on it and see how it goes. Worse case is I change them with the some known good one's that I have.
If you can fit a thin (.o12 or so) feeler gauge between your BB cup and BB shell, you MAY not have the cup completely tight. If a feeler gauge will NOT fit in between, then it is probably seal friction at work. |
Did you have the bottom bracket faced? If the cups are not dead parallel the axle will not spin freely.
|
Originally Posted by rwortman
(Post 11483537)
Did you have the bottom bracket faced? If the cups are not dead parallel the axle will not spin freely.
|
And coaxial with each other. Bottom line is to get the BB chased and faced to make sure the cups are properly positioned.
|
Originally Posted by rwortman
(Post 11483537)
Did you have the bottom bracket faced? If the cups are not dead parallel the axle will not spin freely.
|
well, I figured out my issue. It was my stupidity... Nothing wrong with the bottom bracket or shell. The cable guide under the bottom bracket had a bolt that was too long....... Removed that, cut it, reinstalled, worked fine... Live and learn.
|
Originally Posted by knobster
(Post 11486666)
well, I figured out my issue. It was my stupidity... Nothing wrong with the bottom bracket or shell. The cable guide under the bottom bracket had a bolt that was too long....... Removed that, cut it, reinstalled, worked fine... Live and learn.
Experience is the teacher who gives the final exam first. And you passed! Glad you figured it out! |
All times are GMT -6. The time now is 08:35 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.