rubber boots on hubs??
#1
Senior Member
Thread Starter
Join Date: Mar 2008
Posts: 1,514
Mentioned: 16 Post(s)
Tagged: 0 Thread(s)
Quoted: 231 Post(s)
Likes: 0
Liked 10 Times
in
9 Posts
rubber boots on hubs??
I have some wheel on an older canondale r400 caad3 and it has those rubber boots on the hubs. How do i get around those to do maintence like repacking the bearings? I dont want to pull them off because it would appear they are sealed or pressed into a lip on the hub and im afriad if i pull that lip out of hte hub it wont be able to get it to seat back in there properly.
Is there a trick here? Whats the deal ont these rubber boots? I have another wheelset from a late 90s fuji. Same deal although the previous owner appears to have tried to pull the boot away and ti tore around the lip area. I have not had these apart either because im not sure how to tackle it.
Is there a trick here? Whats the deal ont these rubber boots? I have another wheelset from a late 90s fuji. Same deal although the previous owner appears to have tried to pull the boot away and ti tore around the lip area. I have not had these apart either because im not sure how to tackle it.
#2
Banned
No clue as to the parts pick that is on your bike's build list.
Bike companies are a brand name on a frame,
they buy everything else from other component manufacturing companies
seems no issue taking them off current Shimano boots, on some budget hubs.
Suggest you offer a picture , perhaps? make it a series of close ups.
Bike companies are a brand name on a frame,
they buy everything else from other component manufacturing companies
seems no issue taking them off current Shimano boots, on some budget hubs.
Suggest you offer a picture , perhaps? make it a series of close ups.
Last edited by fietsbob; 09-05-11 at 07:30 PM.
Thread
Thread Starter
Forum
Replies
Last Post
big_rider
General Cycling Discussion
15
01-06-12 07:13 PM