Quick Sturmey Archer Technical Spec Question
#1
Senior Member
Thread Starter
Join Date: Jul 2012
Location: NY Metro
Posts: 87
Bikes: 2010 Masi Gran Criterium, Motobecane ca. 1980 Grand Jubilee, 1984 Trek 500, Specialized Camber Comp 2014
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 1 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Quick Sturmey Archer Technical Spec Question
Hey there,
I just have a quick question about the technical specs listed on SA's website about the S2 hub. They list the PCD (pitch circle diameter) as 67mm. I'm assuming they're referring to the hub flange diameter, as in the distance between the center of one spoke hole to the center of another directly across from it? Because they also list a flange width of 53mm. Correct me if I'm wrong.
Thanks guys!
I just have a quick question about the technical specs listed on SA's website about the S2 hub. They list the PCD (pitch circle diameter) as 67mm. I'm assuming they're referring to the hub flange diameter, as in the distance between the center of one spoke hole to the center of another directly across from it? Because they also list a flange width of 53mm. Correct me if I'm wrong.
Thanks guys!
#2
Really Old Senior Member
Correct
#3
Banned
that would be the diameter.. though It more likely is the center line that runs through all the holes around that circle.
rather than hole to hole,. because they may not be directly across 180 degrees apart.
rather than hole to hole,. because they may not be directly across 180 degrees apart.
#4
Senior Member
Thread Starter
Join Date: Jul 2012
Location: NY Metro
Posts: 87
Bikes: 2010 Masi Gran Criterium, Motobecane ca. 1980 Grand Jubilee, 1984 Trek 500, Specialized Camber Comp 2014
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 1 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Got it. Diameter of spoke holes circle. Thanks a bunch guys!
Thread
Thread Starter
Forum
Replies
Last Post
trnkami1978
Bicycle Mechanics
11
10-22-14 11:39 AM