BB sizing?
#1
Newbie
Thread Starter
Join Date: Jan 2013
Posts: 1
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
BB sizing?
So I took the bb off my 2012 Trek Wahoo. The label on the bb says 73x 122.5. I need to get a new power spline bb for it. Will I need to get a different size for the power spline?
#2
Senior Member
Join Date: Apr 2009
Location: New Rochelle, NY
Posts: 38,696
Bikes: too many bikes from 1967 10s (5x2)Frejus to a Sumitomo Ti/Chorus aluminum 10s (10x2), plus one non-susp mtn bike I use as my commuter
Mentioned: 140 Post(s)
Tagged: 1 Thread(s)
Quoted: 5774 Post(s)
Liked 2,573 Times
in
1,424 Posts
If I'm right, the 73mm stays the same (part of the frame) and you have to get a BB made for that. But the spindle length may change according to the crankset's offset. Usually crank specs mention recommended spindle length someplace.
__________________
FB
Chain-L site
An ounce of diagnosis is worth a pound of cure.
Just because I'm tired of arguing, doesn't mean you're right.
“One accurate measurement is worth a thousand expert opinions” - Adm Grace Murray Hopper - USN
WARNING, I'm from New York. Thin skinned people should maintain safe distance.
FB
Chain-L site
An ounce of diagnosis is worth a pound of cure.
Just because I'm tired of arguing, doesn't mean you're right.
“One accurate measurement is worth a thousand expert opinions” - Adm Grace Murray Hopper - USN
WARNING, I'm from New York. Thin skinned people should maintain safe distance.
#3
Senior Member
Join Date: Feb 2012
Location: Rochester, NY
Posts: 18,071
Bikes: Stewart S&S coupled sport tourer, Stewart Sunday light, Stewart Commuting, Stewart Touring, Co Motion Tandem, Stewart 3-Spd, Stewart Track, Fuji Finest, Mongoose Tomac ATB, GT Bravado ATB, JCP Folder, Stewart 650B ATB
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 4199 Post(s)
Liked 3,853 Times
in
2,303 Posts
Power Spline... Are the arms' spindle holes still in good condition? I have to admit that the PS cranks I've had to deal with have been a disappointment in sourcing parts. Most have had rounded out crank arm/spindle holes. It's a shame that an orphan has survived in the market place for so long. Andy.
Thread
Thread Starter
Forum
Replies
Last Post
jzsoup
Bicycle Mechanics
7
09-11-11 07:34 PM