problem with red rubber seal in odyssey cassette hub - help?
#1
Junior Member
Thread Starter
Join Date: Jul 2004
Posts: 22
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
problem with red rubber seal in odyssey cassette hub - help?
guys,
just bought an odyssey cassette hub, and an odyssey 10t 1pc driver. when i removed the original cog drive mechanism, there was a red rubber seal that fell out. i assumed that i should use it with the 1pc driver as well, but when i do use it - placing it on that ridge just past the pawls, and putting it on the hub - and begin to tighten down the cone nut, the 1pc driver can barely turn at all! when i do this without the red seal/grommet, it turns beautifully.
anyone experience this and figured out how to use the red seal?
thanks.
just bought an odyssey cassette hub, and an odyssey 10t 1pc driver. when i removed the original cog drive mechanism, there was a red rubber seal that fell out. i assumed that i should use it with the 1pc driver as well, but when i do use it - placing it on that ridge just past the pawls, and putting it on the hub - and begin to tighten down the cone nut, the 1pc driver can barely turn at all! when i do this without the red seal/grommet, it turns beautifully.
anyone experience this and figured out how to use the red seal?
thanks.
#2
SPACE FOR RENT
Join Date: Jun 2005
Location: dark side of the moon
Posts: 507
Bikes: 05 kink Cielencki, ody LHD cassete hazard light rear,Ody Vandero front, kink og fork, primo tenderizers,fsa pig headset,ody linear slick cable,FSA nasty boy cranks
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Most people remove the red seal.